Results 1 to 2 of 2

Thread: aisin hub rebuild on land cruiser

  1. #1
    Join Date
    Nov 2006
    Location
    Hamilton/Bracebridge
    Posts
    113
    Time Online: 1 Day 19 Hrs 48 Mins 8 Secs
    Avg. Time Online: 9 Secs
    Rep Power
    11

    aisin hub rebuild on land cruiser

    So I'm attempting to rebuild my aisin manual hubs. I was wondering what is the best grease to repack them with? Thanks in advance.
    1988 Toyota Land Cruiser BJ62 Beige 4DR/V6, Auto/33" BFG A/T's
    1990 Toyota 4runner SR5 Black 4 DR/3.0L V6, Manual/31's/6" Skyjacker/Welded Rear/
    2001 Chevy Silverado LS Ext Cab 4X4 Pewter/265/75/16 BFG A/T's KO
    1991 Chevy Tracker Tintop Brown 2DR/1.6L 4cyl Auto/31" SuperSwampers

  2. #2
    Join Date
    Feb 2008
    Location
    Oshawa
    Posts
    693
    Time Online: 3 Wks 4 Days 19 Hrs 17 Mins 39 Secs
    Avg. Time Online: 2 Mins 7 Secs
    Rep Power
    10
    From my understanding there is not much to replace. Take them off, clean/inspect, replace gaskets/o-rings if needed. I wouldn't pack it full of grease, but some dabs on the inner hub body splines with red Lucas would be my way. They need to move nice and freely. Check the studs that hold the hub on by using two nuts to crank them back down. They tend to pull out. Use a brass drift on the studs to get the cone washers to pop. Do not hit the hub body. Don't over tighten the hardware. I haven't had to do a tear down yet, but this is what I have gathered/ filtered of the interweb.
    1991 Xj Gone to a new home.
    1948 willys Jeep pickup sitting and waiting.
    1984 toyota currently beating & building.

    OF4WD #6069

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •