Results 1 to 3 of 3

Thread: Clutch master cylinder problems

  1. #1
    Join Date
    Dec 2003
    Location
    near K-W
    Posts
    257
    Time Online: 10 Hrs 19 Mins 20 Secs
    Avg. Time Online: 2 Secs
    Rep Power
    14

    Clutch master cylinder problems

    I am putting an ax 15 out of a 99 xj in my 92 yj! The master cyliner on the 99 is to long to fit in the stock location behind the brake mater cylinder. I was wondering if anyone has done this, or if I can use the old master cylinder with the new setup! Help is needed! Thanks guys!

    Mike
    Mikey
    92 Yj Sahara
    I-6 4.0L
    SOA, 2.5" skyjacker leafs, SYE
    33" BFG MT

  2. #2
    Join Date
    Jun 2003
    Location
    Between Lucan and Ailsa Craig, Ontario
    Posts
    3,087
    Time Online: 1 Day 6 Hrs 34 Mins 25 Secs
    Avg. Time Online: 6 Secs
    Rep Power
    18
    Use your old master.
    I did the same thing with my YJ when I went from auto to stick and the pedal was about 4 inches higher than the brake pedal.
    I had to take out the XJ master and put in a YJ master.
    If it isn't broke......... then I must not own it!!!!!

  3. #3
    Join Date
    Dec 2003
    Location
    near K-W
    Posts
    257
    Time Online: 10 Hrs 19 Mins 20 Secs
    Avg. Time Online: 2 Secs
    Rep Power
    14
    So it should still work the same? I am just worried about the clutch not engaging enough! thanks for the reply!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •